Our instructors combined have over fifty years of inspection experience and thirty years of developing their courses and instructing skills.

Fabrication

DTM Enterprises has over 32 years of experience in fabrication; ranging from piping, to pressure vessels, to swing gates and cattle guards, to custom stainless steel bar-b-que pits - our personal favorite!

Facilities

Our facilities are located in Pasadena, Texas, two blocks east of Beltway 8, between Spencer Highway and Red Bluff. on 2603 Dupont. Our classrooms are located at 2757 Dupont, in Pasadena, Texas.

Staff

David McGrath

David has been working in the industry for 30 years and instructing for the API 510, 570 and AWS CWI courses for 11 years. Mr. McGrath was on the staff at two local colleges for 10 years and has developed very effective techniques for relaying the most complex issues. Mr. McGrath has associates degrees in Management and Welding, along with API 510, 570, 653 and American Welding Society CWI certifications.

E-mail: david@dtm-enterprises.org

Chris Marler

Chris Marler has been working in the industry for 16 years and training inspectors for the last 3 years. Mr. Marler has been on staff with DTM Enterprises for the past two years and has developed very effective techniques for relaying the most complex issues. Mr. Marler has held the API 510 certifications for fifteen years and is responsible for the assembly of The Heat Exchanger Book and The Tower Book.

E-mail: chris@dtm-enterprises.org

Rachael Jeter

Rachael is the glue that keeps us all going in the right direction—coordinating printing the test books, chasing down supplies and keeping the rest of us in tune to the program.

E-mail: rachael@dtm-enterprises.org

Classroom Location
2757 Dupont
Pasadena, Texas 77503